GooseTuned 2020-2024 Explorer ST [User-Adjustable] Transbrake Upgrade

**MUST BE CURRENT CUSTOMER TO USE THIS ADD-ON! THIS IS FOR CUSTOM GOOSTUNED TRANBRAKE***
 
**CANNOT ADD THIS PRODUCT TO COBB OTS MAP.
 
 
TRANSBRAKE
 
Now that the tires are nice and warm your Explorer ST  pulls up to the starting line.  We all know that a good launch is one of the most critical parts of any drag race.  The new transbrake feature helps to have that covered.  Not only will your 60ft times more consistent but they’ll also be faster by allowing a greater amount of boost to be built off the line.

In testing, with brake boosting the ST (just holding the brake in stock configuration and pressing the throttle), we were able to generate up to 10PSI before the rear wheels were overcome and began spinning.  With the transbrake feature, and raising the 2-step RPM, the car reaches over 15psi!
To enable the transbrake feature go to “Tune” > “Adjustments” > “Enable Transbrake” > Set the value to “1” using the up button and press enter (center button).
 
 
BUMP BOX
 
The Bump Box feature allows you to “bump” the car forward to illuminate the staging lights.  Depending on how high of an RPM you have set, how much boost you want to build, and how fast the tree operator wants to start the lights, the bump box can be a major benefit.  If you were to fully stage the car, there may not be enough time to reach the desired RPM or to build the appropriate boost.  With this feature, you can do all of that prior to fully staging the car.  To use this feature
Enable the Transbrake feature on the Accessport.
Depress the brake pedal to 100%.
While holding the brake pedal down, fully depress the gas pedal to 100%.
The Engine will rev to 2500 (default) or your specified RPM (if the 2-step limiter is enabled) and begin to build boost.
Press the “Set +” cruise control button to bump the car forward. You can do this repeatedly if you wish.
Release the brake pedal completely and keep the gas pedal at 100%. This will release the transbrake and launch the vehicle!
 
You are able to change the amount of “bump.”  This can be adjusted through  “Tune” > “Adjustments” > “Change Transbrake Bump Delay” > Set the value to your desired bump using the up/down buttons and press enter (center button).